Vu+
  1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Motor adjustment from PC ?

Discussion in 'Newbies Questions & Infos' started by groucho78, Mar 7, 2016.

  1. groucho78

    groucho78 Vu+ Newbie

    Messages:
    6
    Is it possible to link a program such as "Prog Finder" (progdvb.com/prog_sat_finder.html) or something simillar to my Vu Solo2?

    To send disecq1.2 commands and adjust the dish this way?

    I can not find (after several days) the Telstar at 15W with the installed Positioner Setup ...

    Thanks
     
  2. Mick12334

    Mick12334 Moderator

    Messages:
    2,425
    Can you please post your general location, and the size of your dish.
    If you can't get 15W by manually moving your dish, using the fine positioner options, then I doubt a computer program will work.
     
  3. groucho78

    groucho78 Vu+ Newbie

    Messages:
    6
    I've my longitude and latitude entered, the dish is 100cm. My location is Flanders just under the Dutch border.
    What would be the strongest transponder on Telstar?
     
  4. Mick12334

    Mick12334 Moderator

    Messages:
    2,425
    Probably one on the Europe beam, I'd try Jim Jam, 11150 V 19279 DVB-S:
    Code:
    http://www.lyngsat-maps.com/footprints/Telstar-12-Europe.html
     
  5. groucho78

    groucho78 Vu+ Newbie

    Messages:
    6
    Success. Had to adjust the elevation and declination angle on the dish. Was 99% on the Astra before but when turning to Telstar apparently not good enough.
    12608 H is a good frequency to point to. (Gunaz TV)
    It's mostly for the DAD-5 feed. (American live feed of NBC, CNBC at night)
     
    el bandido likes this.
  6. msginnie

    msginnie Vu+ Newbie

    Messages:
    17
    This can only be done by technical person from relevant field.
     

Share This Page